Installation guide

Switch Security
6-102
6.11.4 Reviewing the Probes Report
Refer to the Probes Found tab to view the enhanced Probe report created by the switch. The table displays
probe information collected during the AP’s channel scan. The information displayed within the Probes Found
tab is read-only with no user configurable parameters.
To view the enhanced beacons table report:
1. Select Security > Enhanced Probe/Beacon Table from the main menu tree.
2. Select the Probes Found tab.
3. Refer to the following information as displayed within the Probes Found tab.
4. Click the Clear Report button to reset the statistic counters to zero and begin new calculations.
Portal MAC The MAC address of the unadopted MU picked up by the Enhanced Probes
enabled AP.
MU MAC The MAC address of the Enhanced Probe detected MU.
Signal Strength
(dBm)
The signal strength when the unadopted MU was detected.
Heard Channel The channel frequency used when the unadopted MU was detected.
Heard Time The time when the unadopted MU was detected.