Installation guide

Overview
1-22
1.2.3.4 Interface Management
The switch permits a physical interface to Auto Negotiate, Full Duplex or Half Duplex. The switch also allows:
• Manual bandwidth configuration of a physical interface to 10/100/1000Mbps. This is only permitted
if duplex is not set to Auto Negotiate.
• Manual configuration of administrative shutdown of a physical interface.
1.2.4 Management Features
The switch includes the following management features:
• A secure browser-based management console
•A Command Line Interface (CLI) accessible via the serial port or a Secure Shell (SSH) application
• The CLI Service mode enables the capture of system status information that can be sent to Customer
Support personnel for use in problem resolution
• Support for Simple Network Management Protocol (SNMP) version 3 as well as SNMP version 2
• The TFTP upload and download of access port firmware and configuration files
• The graphing of wireless statistics
• A dashboard summary of system state in the Web UI
• Multi switch management via MSP application
• Heat map support for RF deployment
• Secure guest access
• Switch discovery enabling users to discover each switch on the specified network.
1.2.5 Security Features
Switch security can be classified into wireless security and wired security
The switch includes the following wireless security features:
• Encryption and Authentication
• MU Authentication
• Secure Beacon
• MU to MU Allow
• MU to MU Disallow
• Switch - to - Wired
• 802.1x Authentication
• WIPS
• Rogue AP Detection
The switch includes the following wired security features:
• ACLs
• Local Radius Server
• IPSec VPN
• NAT
• Firewall