Installation guide

Switch Security
6-43
2. Click the Configurations tab.
During IKE negotiations, peers must identify themselves to one another. Thus, the configuration you
define is the identification medium for device recognition.
3. Set a Keep Alive interval (in seconds) the switch uses for monitoring the continued presence of a
peer and report of the client's continued presence. The client notifies you when the peer is no longer
present. The default interval is 10 seconds.
4. Click the Apply button (within the IKE Settings field) to save the configuration.
5. Click the Revert (within the IKE Settings field) to rollback to the previous configuration.
6. Refer to the Pre-shared Keys field to review the following information:
7. Highlight an existing set of pre-shared Keys and click the Edit button to revise the existing peer IP
address, key and aggressive mode designation.
Peer IP Address Use the Peer IP Address to associate an IP address with the specific tunnel
used by a group of peers.
Aggressive Mode Displays whether aggressive mode is enabled for this IP address and key
string. A green check mark defines aggressive mode as enabled. A red “X”
denotes the mode as disabled.
Key Displays the string ID a remote peer uses to look up pre-shared keys.
NOTE Please note that RSA keys are not supported for IKE negotiation on this switch.
.