Installation guide

Switch Security
6-41
6.6.4 Viewing NAT Status
Use the Status tab to review the NAT translations configured thus far for the switch. The Status tab displays
the inside and outside local and global IP addresses.
To view and configure a NAT interface:
1. Select Security > NAT from the main menu tree.
2. Click on the Status tab.
3. Refer to the following to assess the validity and total NAT translation configurations available to the
switch.
4. Click on the Export button to export the contents of the table to a Comma Separated Values file
(CSV).
Inside-Global
NATed source IP address of the packet for source NAT translation.
This address will be same as the inside local address for
destination NAT translation.
Inside Local Actual source IP address of the packet.
Outside-Global
NATed destination IP address of the packet for the destination
NAT translation. This address will be same as the outside local
address for source NAT translation.
Outside-Local Actual destination IP address of the packet.