Installation guide

Switch Services
5-52
2. Select the MU Status tab.
3. Refer to the following information within the MU Status tab:
MU MAC Displays the factory hardcoded MAC address of the MU. This value
is set at the factory and cannot be modified. Thus, it should be
consistent as the MU roams within the mobility domain.
MU IP Addr Displays the IP address the MU is using within the mobility domain.
Again, this may not be the IP address used by the MU for initial
association with the switch, but it is the IP address set for the MU
to roam amongst subnets. For more information, see
Configuring Layer 3 Mobility on page 5-46.
Home Sw IP Displays the MU’s home switch IP address. This is the IP address of
the switch the MU is initially associated with, before roaming
across subnets as part of its layer 3 mobility activity.
Home Sw VLAN Displays the MU’s home switch VLAN identifier. This is the VLAN
index value set for the MU when it was originally configured as
part of a VLAN with its home switch.
Curr Sw IP Displays the IP address of the switch the MU is currently
associated to within the mobility domain.
Roam Displays whether the MU has roamed (with a checkmark) or has
not roamed (with an X).