Installation guide

Switch Services
5-42
2. Select the Member tab.
3. Refer to the following information within the Member tab:
IP Address Displays the IP addresses of the selected redundancy group
member.
Status Displays the current status of this group member. This status could
have the following values:
• Configured - The member is configured on the current
switch.
• Seen - Heartbeats can be exchanged between the
current switch and this member.
• Invalid - Critical redundancy configuration parameter(s)
of the peer (heartbeat time, discovery time, hold time,
Redundancy ID, Redundancy Protocol version of this
member) do not match this switch’s parameters.
• Not Seen - The member is no longer seen by this switch.
• Established - The member is fully established with this
current module and licensing information already been
exchanged between this switch and the member.
Last Seen Displays the time when this member was last seen by the switch.
Adoption Count Displays the number of access ports adopted by this member.
License Count Displays the number of licenses installed on this member. For
information on licensing rules impacting redundancy group
members, see
Redundancy Group License Aggregation Rules on page 5-45.
Mode The Redundancy Mode could be Active or Standby depending on
the mode configuration on the member. Refer to the Configuration
screen to change the mode.