Installation guide

Switch Services
5-41
4. The Apply and Revert buttons are unavailable for use with the Status screen, as there are no
editable parameters to save or revert.
5.4.2 Configuring Redundancy Group Membership
The redundancy group should be disabled to conduct an Add/Delete operation. There are a minimum of 2
members needed to comprise a Redundancy Group, including the initiating switch
To configure switch redundancy memberships:
1. Select Services > Redundancy from the main menu tree.
The Redundancy screen displays with the Configuration tab selected.
Connectivity Status Displays the current connectivity status of the cluster membership.
Access Ports on this
switch
Displays the total of the number of access ports adopted by this
switch.
Adoption capacity on
this switch
Displays the AP adoption capability for this switch. Compare this
value with the adoption capacity for the entire cluster to determine
if the cluster members (or this switch) have adequate adoption
capabilities.
Rogue Access Ports
on this switch
Displays the number of rogue APs detected by this switch.
Compare this value with the cumulative number of rogues detected
by the group to discern whether an abundance of rogues has been
located by a particular switch and thus escalates a security issue.
Radios on this switch Displays the number of radios used with this switch.
Self-healing radios on
this switch
Displays the number of radios on this switch with self-healing
enabled. Compare this value with the total number of radios within
the group to determine how effectively radios can self-heal if
problems exist.
Mobile Units on this
switch
Displays the number of MUs currently associated with the radio(s)
used with this switch. Compare this number with the number of
MUs within the group to determine how effectively MUs are
distributed within the cluster.