Installation guide

Network Setup
4-131
2. Click on OK button to save and commit the new configuration.
3. Click Cancel to disregard the changes and revert back to the previous configuration.
4.10.4 Viewing and Configuring Port Instance Details
Use the Port Instance tab to view and configure MST port instance parameters, including Port Priority and
Admin Internal Path Cost.
To view and configure the MSTP bridge instance:
1. Select Network > Multiple Spanning Tree from the main menu tree.
Port Path Cost Define the path cost for the specified port index. The cost is 1,000
Mbps (1 gigabit per second) divided by the bandwidth of the
segment connected to the port. Therefore, a 10 Mbps connection
would have a cost of (1,000/10) 100.
Admin Point-to-Point
status
Define the point-to-point status as ForceTrue or ForceFalse.
ForceTrue indicates this port should be treated as connected to a
point-to-point link. ForceFalse indicates this port should be treated
as having a shared connection.
Port Enable Select this checkbox to use this port for the forwarding of MST
supported packets on the switch.
Port Migration If enabled, protocol migration enables the switch (when running
MST) to interoperate with legacy 802.1d switches. If the listed
index receives a legacy 802.1D configuration BPDU, it only sends
802.1D BPDUs over its port.
Admin Edge Port Select the checkbox to define this port index as an admin edge port.