User manual

Common Commands
2-33
pm sys-restart Process Monitor
• sys-restart – Enables the PM to restart the system when
a processes fails
prompt crash-info Enable crash-info prompt
• crash-info – Enables a crash-info prompt
radius restart Enable radius server
• restart – Restarts the radius server with an updated
configuration
redundancy dynamic-ap-
load-balance start
Configure redundancy group parameters
• dynamic-ap-load-balance start – Enables the Dynamic
AP Load Balance feature
• start – Start dynamic AP load balance
set [command-history
|reboot-history|
upgrade-history]
Set service parameters.
• command-history <10-300> – Sets the size of the
command history (default is 200)
• reboot-history <10-100> – Sets the size of the reboot
history (default is 50)
• upgrade-history <10-100> – Sets the size of the upgrade
history (default is 50)
show Shows running system information
• cli – Shows the CLI tree of the current mode
terminal-length <0-512> System wide terminal length configuration
• <0-512> – Number of lines of VTY (0 means no line
control)
watchdog Enables the watchdog