User manual

Motorola RF Switch CLI Reference Guide
20-124
smart-scan-channels
[<channel-list>|
add <channel-list>|
remove <channel-list>]
Specifies a list of channels to motorola clients to perform a
smart-scan. The following are the options set:
• <channel-list> – A comma separated list of channels to
scan. Can also contain a single channel number.
• add <channel-list> – Adds the specified channel(s) to the
smart-scan list.
• remove <channel-list> – Removes the specified
channel(s) from the smart-scan list.
ssid <ssid> Enter the SSID of this WLAN. <ssid> can be up to 32
characters.
storm-control
[bcast|mcast|ucast]
rate-limit <rate>
Enables packet dropping in case of flooding attack.
• bcast – broadcast packets
• mcast – multicast packets
• ucast – unicast packets
• rate-limit <rate>– Enables rate limiting if the rate
exceeds the value set by <rate> (1-1000000 packets/
second).
syslog accounting server
<IP> {port <1-65535>}
Syslog Accounting
• accounting – Modifies accounting parameters
• server <IP> – Modifies the Syslog accounting server IP
Address.
• port <1-65535> – Optional. Defines the Syslog server
port. The default port number is 514 .
vlan [<1-4094>|
<vlan-list>]
{limit <0-8192>}
Sets the VLAN assignment of this WLAN. This command
starts a new VLAN assignment for a WLAN index. All prior
VLAN settings are erased.
• [<1-4094>|<vlan-list>] –Establishes the VLAN range list.
It can be either a single index, a list (1,3,7) or a range (3-
7).
• limit <0 -8192> – Sets user limits on VLANs for this
WLAN.