User manual

Motorola RF Switch CLI Reference Guide
20-74
nas-id <ID> Configures a NAS ID for this radio. <ID> can be up to 256
characters long.
nas-port-id <ID> Configures a NAS port id for this radio. <ID> can be up to
256 characters long.
on-channel-scan Enables rogue scanning on this radio.
radio-number <0-2> Enter the radio number only if there are two similar radios
on the AP. Enter 0 (zero) or omit when there is no ambiguity.
reset Resets a radio (this will only reset the specified radio, not
the complete access port).
reset-ap Resets the parent AP (this will reset all radios on that
access port).
rf-function wips Selects the rf-function for the selected radio.
• wips – Selects WIPS sensor mode.
rf-mode [a|an|b|bg|bgn|
custom|g|n]
Selects the radio speed based on the radio mode selected.
rss enable Remote Site Survivability (RSS) enables the delivery of
secure uninterrupted wireless service in remote locations in
the event of a device failure.
rts-threshold <0-2347> Defines the RTS threshold in bytes.
run-acs Runs an auto-channel-selection on a radio. The radio should
already have been configured for ACS support.
self-heal-offset <0-30> Configures the self-healing offset (measured in dBm), for
regulatory compliance.
Note: The offset is based off the regulatory maximum
power for the specified channel ("show wireless regulatory"
displays the max power allowed).
short-gi enable Enables the Short GI value for both the 20 MHz and the 40
MHz channels for the 11n radio.