User manual

Wireless Instance
20-73
dtim-period<1-50> {bss
<1-4>}
Set the DTIM period (number of beacons between
successive DTIMs).
• <1-50> – Sets the DTIM period
• bss <1-4>– Optional BSS index
enforce-spec-mgmt
enable
Enforces spectrum management checks on specified radios.
Only mobile units that advertise spectrum management
capabilities will be allowed to associate on this radio.
enhanced-beacon-table Enables the enhanced beacon table for AP locationing.
enhanced-probe-table Enables the enhanced probe table for MU locationing.
group-id <1-256> Specifies the radio groups to balance user load.
• For RFS7000, <0-255> – Radio group identifier used for
an access-port, 0 disables the grouping.
• For RFS6000, <0-64> – Radio group identifier used for an
access-port, 0 disables the grouping.
location-led
[start-flashing|
stop-flashing]
Changes the mode of operation of the LEDs on an AP.
• start-flashing – Requests parent-ap of specified radio to
begin flashing its LEDs to help locate it.
• stop-flashing – Requests parent-ap of specified radio to
revert its LEDs to normal mode of operation.
location-message
<message>
Specifies a message sent to all mobile units that associate
with these radios. This message <message> should not
exceed 80 characters.
mac <MAC> Changes the parent (access-port) MAC address of the radio.
max-mobile-units
<1-256>
Maximum number of mobile units allowed to associate.
mu-power <0-20> Power adjustment level for mobile units associated with
this access-port. MUs that support this element will reduce
their transmit power by the specified value.
• <0-20> – Power adjustment level in dBm.