User manual

Radius Server Instance
19-35
19.1.15 service
 Radius Configuration Commands
Invokes the service commands to troubleshoot or debug the (config-radsrv) instance
configuration
This command is also used to enable the RADIUS server.
Supported in the following platforms:
• RFS7000
• RFS6000
Syntax
service show cli
Parameters
None
Example
RFSwitch(config-radsrv)#service show cli
Radius Configuration mode:
+-authentication
+-data-source
+-ldap [authentication data-source (local|ldap)]
+-local [authentication data-source (local|ldap)]
+-eap-auth-type
+-all [authentication eap-auth-type (ttls-md5|ttls-
pa p|ttls -msch apv2| p eap- g t
c|peap-mschapv2|tls|all)]
+-peap-gtc [authentication eap-auth-type (ttls-md5|ttls-
pap|ttls-mschapv2|pe
ap-gtc|peap-mschapv2|tls|all)]
+-peap-mschapv2 [authentication eap-auth-type (ttls-
md5|ttls-pap|ttls-mschap
v2|peap-gtc|peap-mschapv2|tls|all)]
+-tls [authentication eap-auth-type (ttls-md5|ttls-
pa p|ttls -msch apv2| p eap- g t
c|peap-mschapv2|tls|all)]
+-ttls-md5 [authentication eap-auth-type (ttls-md5|ttls-
pap|ttls-mschapv2|pe
ap-gtc|peap-mschapv2|tls|all)]
+-ttls-mschapv2 [authentication eap-auth-type (ttls-
md5|ttls-