User manual

Motorola RF Switch CLI Reference Guide
17-6
17.1.3 class
 DHCP Config Commands
Associates a DHCP class with a pool
This command is used in Step 4 of Creating a DHCP User Class.
The CLI prompt moves to a sub-instance
(config-dhcp-class).The configuration mode
changes from
(config-dhcp)# class to (config-dhcp-class).
Refer to config-dhcp-class on page 17-7 for a
(config-dhcp-class) command summary.
Supported in the following platforms:
• RFS7000
• RFS6000
Syntax
class <class-name>
Parameters
Example
RFSwitch(config-dhcp)#class RFS7000DHCPclass
RFSwitch(config-dhcpclass)#
17.1.3.1 Creating a DHCP User Class
Follow the steps below to create a DHCP User Class:
1. Create a DHCP class named
RFSwitchDHCPclass. The switch supports a maximum of
32 DHCP classes.
RFSwitch(config)#ip dhcp class RFS7000DHCPclass
RFSwitch(config-dhcpclass)#
2. Create a USER class named MC800. The mode changes to (config-dhcpclass). The
switch supports a maximum of 8 users classes per DHCP class.
RFSwitch(config-dhcpclass)#option user-class MC800
RFSwitch(config-dhcpclass)#
class <class -name> Associates a class with a pool and enters the
DHCP pool class configuration mode