User manual

Motorola RF Switch CLI Reference Guide
12-28
12.1.18 speed
 Interface Config Commands
Specifies the speed of a fast-ethernet (10/100) or a gigabit-ethernet port (10/100/1000)
Displays current system information running on the switch.
Supported in the following platforms:
• RFS7000
• RFS6000
Syntax
speed [10|100|1000|auto]
Parameters]
Usage Guidelines
Set the interface speed to auto to detect and use the fastest speed available. Speed
detection is based on connected network hardware.
Example
RFSwitch(config-if)#speed auto
RFSwitch(config-if)#
10 Forces 10 Mbps operation
100 Forces 100 Mbps operation
1000 Forces 1000 Mbps operation
auto Port automatically detects the speed it should run based on
the port at the other end of the link.Autonegotiation is a
requirement for using 1000BASE-T[3]
according to the
standard.