User manual

Motorola RF Switch CLI Reference Guide
12-2
ip Sets the IP address for the assigned ethernet, VLAN or
tunnel
page 12-10
mac Applies a MAC access list to a gigabit ethernet
interface
page 12-13
management Sets the selected interface as the management
interface
page 12-14
no Negates a command or sets its defaults page 12-15
port-channel Configures the load-balancing criteria of an aggregated
port
page 12-16
power PoE (Power Over Ethernet) commands used to configure
PoE power limit and priority for a port
page 12-19
service Invokes service commands to troubleshoot or debug
the
(config-if) instance configurations
page 12-21
show Displays running system information page 12-22
shutdown Shuts down a selected interface page 12-24
spanning-tree Disables the selected interface. The interface is
administratively enabled unless explicitly disabled
using this command
page 12-25
speed Specifies the speed of a fast-ethernet (10/100) or a
gigabit ethernet port (10/100/1000)
page 12-28
static-
channel-
group
Configures static channel commands page 12-29
storm-control Sets broadcast rate-limit value page 12-32
switchport Sets switching mode characteristics page 12-30
Table 12.1 Interface Config Command Summary (Continued)
Command Description Ref.