User manual

Interface Instance
Use the (config-if) instance to configure the interfaces – Ethernet, VLAN and tunnel
associated with the switch.
To switch to this mode, use the command:
RFSwitch(config)#interface [<interface-name>|ge <1-4>|me1|
sa <1-4>|vlan <1-4094>
RFSwitch(config-if)#
12.1 Interface Config Commands
Table 12.1 summarizes the (config-if) commands:
Table 12.1 Interface Config Command Summary
Command Description Ref.
clrscr Clears the display screen page 12-3
crypto Defines the encryption module page 12-4
description Creates an interface specific description page 12-5
duplex Sets the duplex mode used by the interface page 12-6
end Ends the current mode and moves to the EXEC mode page 12-7
exit Ends the current mode and moves to the previous mode page 12-8
help Displays the interactive help system page 12-9