User manual

Introduction
1-11
RFSwitch# co
1.4.3 Deleting Entries
Use any of the following keys (or key combinations) to delete command entries:
1.4.4 Re-displaying the Current Command Line
If entering a command and the system suddenly sends a message, you can recall the
current command entry. To re-display the current command line (refresh the screen), use
the following key combination:
1.4.5 Command Output pagination
Output often extends beyond the visible screen length. For cases where output continues
beyond the screen, the output is paused and a
Press Any Key to Continue (Q to
Quit)
prompt displays at the bottom of the screen. To resume the output, press the Return
key to scroll down one line or press the Spacebar to display the next full screen of output.
NOTE: The characters entered before the question mark are reprinted
to the screen to complete the command entry.
Keystrokes Purpose
Backspace Deletes the character to the left of the cursor
Ctrl-D Deletes the character at the cursor
Ctrl-K Deletes all characters from the cursor to the end of the command line
Ctrl-W Deletes a word up to the cursor
Esc, D Deletes from the cursor to the end of the word
Keystrokes Purpose
Ctrl-L Re-displays the current command line