Installation guide

Network Setup 4-11
3. Select a record from the table and click the Edit button to modify the record. For more information, see
Editing the Details of an Existing VLAN by Port on page 4-11.
4.3.2 Editing the Details of an Existing VLAN by Port
To revise the configuration of an existing VLAN:
1. Select Network > Virtual LANs from the main menu tree.
2. Select an Ethernet for which you want to configure the VLAN and click on the Edit button.
The system prompts you with a Port VLAN Change Warning message stating communication
disruptions could occur with the switch.
3. Click OK to continue.
4. Use the Edit screen to modify the VLAN’s mode, access VLAN and allowed VLAN designation.
Allowed VLANs Displays VLAN tags allowed on this interface
Native VLAN Tagged Displays if the Native VLAN for each port is tagged or not. The column displays a
green check mark if the Native VLAN is tagged. If the Native VLAN is not tagged
the column will display a red “x”.
A Native VLAN is the VLAN which untagged traffic will be directed over when
using a port in trunk mode.
SWITCH NOTE: For Adaptive AP to work properly with RFS7000 you need to have
independent and extended WLANs mapped to a different VLAN than the ge port.