Installation guide

D-97
• 5 AP300 model Access Ports
D.7.6.3 Unauthorized AP Detection
As shown in the figure below, a switch is deployed at a site with four AP300s. The administrator wants to
enable unauthorized AP detection to be proactively alerted when any APs are added or removed from the
site.
To support the detection of unauthorized APs, three AP300sare configured to perform single channel
scanning while simultaneously providing WLAN services to users. The three APs monitor 2.4GHz channels
(1, 6 and 11) and 5GHz channels (36, 40 and 48). The fourth AP300 is configured as a dedicated detector AP
and monitors all the channels within the regulatory domain. APs provide the switch with complete visibility
into the 2.4GHz and 5GHz spectrum at this site using three AP300s with single channel scanning and a
dedicated detector.
Switch Web UI Configuration
The following configuration example demonstrates how to globally enable unauthorized AP detection on an
RF Switch and configure AP300 scanning options:
1. From the switch menu tree select Network > Access Port Radios.
2. Select the Configuration tab.
3. Highlight and select an AP300 radio then click Edit.