Installation guide

D-80 Motorola RF Switch System Reference Guide
12.Highlight and select the AP300s then select Edit.
13.Un-check the Pre Staging Mode option and select OK.
The updates are reflected within the Secure WISPe table.
14.Select Save (from the lower left-hand corner) to apply the changes.
D.6.5.4 Enabling Secure WISPe on New AP300s
As depicted in the illustration below, a new AP300 is added to an RF Switch with four existing AP300s with
secure WiSPe enabled. Enabling secure WiSPe for new AP300s in an existing WiSPe deployment requires
the following:.