Installation guide

D-77
D.6.5.2 Components
The information in this section is based on the following Motorola hardware and software versions:
• 1 RFS6000 model switch
• 5 AP300 model access ports
D.6.5.3 Enabling Secure WISPe on Existing AP300s
As depicted in the illustration below, an RF Switch is deployed at a site with four AP300s adopted (at L3). An
administrator wants to enable secure WiSPe on the existing AP300s to secure management and control
frames and provide authentication.
Enabling secure WiSPe for an existing deployment requires the following:
• A secure WiSPe shared secret for each AP
• Pre staging and secure mode be enabled for each adopted AP300
• The four AP300s be reset during a scheduled maintenance window to allow the shared key to be applied
• Pre staging be disabled once the AP300s have been re-adopted by the RF Switch
Web UI Configuration
The following configuration example demonstrates how to enable secure WiSPe for existing AP300s on a RF
Switch:
1. From the switch menu tree select Network > Access Port.
2. Select the WISPe tab.
MAC Address Secure Mode Pre Staging Shared Secret
00-15-70-78-f5-23 Enabled Enabled pre shared key
00-15-70-b2-fd-cf Enabled Enabled pre shared key
00-15-70-b2-fd-d0 Enabled Enabled pre shared key
00-15-70-d5-da-fb Enabled Enabled pre shared key