Installation guide

3-12 Motorola RF Switch System Reference
3. Select a port and click the Edit button to modify the port configuration. For additional information, see
Editing the Port Configuration.
3.2.1.1 Editing the Port Configuration
To modify the port configuration:
1. Select a port from the table displayed within the Configuration screen.
Name Displays the current port name. The port names available vary by switch.
RFS6000: ge1, ge2, ge3, ge4, ge5, ge6, ge7, ge8, me1, up1
RFS7000: ge1, ge2, ge3, ge4, me1
MAC Address Displays the port’s MAC Address. This value is read-only, set at the factory and
cannot be modified.
Admin Status Displays whether the port is currently Up or Down.
Speed Displays the current speed of the data transmitted and received over the port.
Duplex Displays the port as either half or full duplex.
Medium Displays whether the connection medium is cooper or not.
SWITCH NOTE: On a RFS7000, the MAC address for the me1 port changes when the
switch firmware is updated to the 1.3 version. This addresses an issue where the switch
MAC address and ge1 interface shared the same MAC address in previous versions.