Installation guide

D-24 Motorola RF Switch System Reference Guide
3. Define the name for zone 2 by issuing a zone command.
Syntax: zone <zone-id> <name>
RFS7000(config-rtls)# zone 2 name Secure Area
4. Using the zone command, enter each point on the perimeter for zone 2 (in order). In this example, zone
2 includes 4 points which should each be entered in order (counterclockwise).
Syntax: zone <zone-id> perimeter x <value> y <value>
RFS7000(config-rtls)# zone 2 perimeter x 0 y 0
RFS7000(config-rtls)# zone 2 perimeter x 45 y 0
RFS7000(config-rtls)# zone 2 perimeter x 45 y 23
RFS7000(config-rtls)# zone 2 perimeter x 0 y 23
5. Define the name for zone 3 by issuing zone command.
Syntax: zone <zone-id> <name>
RFS7000(config-rtls)# zone 3 name Warehouse
6. Using the zone command enter each point on the perimeter for zone 3 (in order).
In this example, zone 3 includes 6 points which should each be entered in order (counterclockwise).
Syntax: zone <zone-id> perimeter x <value> y <value>
RFS7000(config-rtls)# zone 3 perimeter x 0 y 23
RFS7000(config-rtls)# zone 3 perimeter x 64 y 23
RFS7000(config-rtls)# zone 3 perimeter x 64 y 28
RFS7000(config-rtls)# zone 3 perimeter x 80 y 28
RFS7000(config-rtls)# zone 3 perimeter x 80 y 60
RFS7000(config-rtls)# zone 3 perimeter x 0 y 60