Installation guide

D-6 Motorola RF Switch System Reference Guide
A confirmation screen displays the following message: Converting the AP will UNADOPT all its
radios. Do you want to continue?
10.Select Yes to confirm the conversion.
A Conversion in progress.....screen displays.
11.Select OK to proceed.
12.Select Save (from the lower left-hand corner) to apply the changes.
After several minutes, select Network > Access Port Radios from the switch menu tree.
13.Select the Sensor tab.
The converted sensors display within in the Sensor Display Table.
Reverting Sensors Into Access Ports
To revert a sensor back into an Access Port:
1. From the switch menu tree select Network > Access Port.
2. Select the Sensor tab.