Installation guide

D-4 Motorola RF Switch System Reference Guide
To convert the AP300s into sensors:
1. From the switch menu tree select Network > Access Port.
2. Select the Sensor tab.
3. In the VLAN ID field, enter the VLAN ID where sensors are installed.
In this example sensors are located on VLAN 12. Click Apply.
4. From the switch menu tree select Network > Access Port Radios.
CAUTION: For the AP300 sensor conversion process to work, an AP300s must be L2
adopted to the RF Switch. L3 adopted AP300s cannot be converted into AirDefense
sensors.
!