Installation guide

Switch Management 7-11
• Enabling Trap Configuration
• Configuring Trap Thresholds
7.4.1 Enabling Trap Configuration
If unsure whether to enable a specific trap, select it and view a brief description that may help your decision.
Use Expand all items to explode each trap category and view all the traps that can be enabled. Traps can
either be enabled by group or as individual traps within each parent category.
To configure SNMP trap definitions:
1. Select Management Access > SNMP Trap Configuration from the main menu tree.
2. Select the Allow Traps to be generated checkbox to enable the selection (and employment) of all the
traps within the screen. Leaving the checkbox unselected means traps must be enabled by category or
individually.
3. Refer to trap categories within the Configuration screen to determine whether traps should be enabled
by group or individually enabled within parent groups.