Installation guide

Switch Management 7-7
1. Select Management Access > SNMP Access from the main menu tree.
2. Select the V3 tab from within the SNMP Access screen.
3. Refer to the fields within the V3 screen for the following information:
4. Highlight an existing v3 entry and click the Edit button to modify the password for the Auth Protocol and
Priv Protocol.
For additional information, see Editing an Existing SNMP v1/v2 Community Name on page 7-6
5. Highlight an existing SNMP v3 User Name and click the Enable button to enable the log-in for the
specified user. When selected the status of the user is defined as active.
6. Highlight an existing SNMP v3 User Name and click the Disable button to disable the log-in for the
specified user. When selected the status of the user is defined as inactive.
User Name Displays a read-only SNMP v3 username of operator or Admin. An operator
typically has an Access Control of read-only and an Admin typically has an Access
Control of read/write.
Access Control Displays a read-only (R) access or read/write (RW) access for the v3 user. Read-only
access allows the user (when active) to retrieve information, while read/write
access grants the user modification privileges.
Authentication Displays the current authorization scheme used by this user for v3 access to the
switch. Click the Edit button to modify the password required to change
authentication keys.
Encryption Displays the current Encryption Standard (DES) protocol the user must satisfy for
SNMP v3 access to the switch. Click the Edit button to modify the password
required to change encryption keys.
Status Displays whether this specific SNMP v3 User Name is active on the switch. For
more information, see Accessing SNMP v2/v3 Statistics on page 7-9.