Installation guide

6-22 Motorola RF Switch System Reference Guide
10.From the Filters field, enter the Source Address where the packets are sourced.
11.Select a Source Wildcard/Mask from the drop-down menu.
The Source Wildcard/Mask is the size of the network or host (in mask format). The mask length
defines a match based on the Network / Host.
12.Refer to the Status field for the state of the requests made from applet. This field displays error
messages if something goes wrong in the transaction between the applet and the switch.
13.Click OK to use the changes to the running configuration and close the dialog.
14.Click Cancel to close the dialog without committing updates to the running configuration.
6.4.3 Attaching an ACL on a WLAN Interface/Port
Use the Attach-WLAN tab to view and assign an ACL to a WLAN on the switch. If a MAC ACL is being
attached, create a ACL entry to allow an ARP with the least precedence.
To configure a WLAN ACL:
1. Select Security > Wireless Firewall from the main menu tree.
2. Select the Security Policy tab.
3. Select the Attach-WLAN tab.
NOTE: If an Extended IP ACL is used, a Destination Wildcard/Mask and Destination
Address are required.
NOTE: WLAN based ACLs allows users to enforce rules/ACLs on both the inbound and
outbound direction, as opposed to Layer 2 ACLs, which just support the inbound direction.