Installation guide

6-18 Motorola RF Switch System Reference Guide
6.4.2 Configuring the Firewall
Configure the Firewall to create either standard/extended ip or extended MAC access control lists.
To configure the Firewall:
1. Select Security > Wireless Firewall from the main tree menu.
2. Select the Configuration tab.
3. Select the ACL tab.
4. Add a new ACL entry as explained in Adding a New ACL on page 6-19.
5. The Configuration tab consists of the following two fields:
• ACLs - existing access lists
• Associated Rules - allow/deny rules
The ACLs field displays the list of ACLs currently associated with the switch. An ACL contains an ordered
list of ACEs. Each ACE specifies a permit or deny designation and a set of conditions the packet must
satisfy to match the ACE. Because the switch stops testing conditions after the first match, the order of
conditions in the list is critical.
6. If an existing ACL no longer satisfies switch access control requirements, select it from amongst the
existing ACLs and click the Delete button.
7. Use the Add button (within the ACLs field) to add an additional ACL. For more information, see Adding a
New ACL on page 6-19.
8. To reset the Hit Count number, click the Clear button.
9. Refer to the Associated Rules field to assess the rules and precedence associated with each ACL. If
necessary, rules and can be added or existing rules modified. For more information, see Adding a New
ACL Rule on page 6-19.