Installation guide

5-70 Motorola RF Switch System Reference
4. Enter the Multicast MAC Address used for all Ekahau tags to send updates via multicast to the MAC
address specified. Typically the MAC address will start with 01-0C-CC-XX-XX-XX.
5. Specify the IP Address of the Ekahau RTLS engine server.
6. Enter the Port number used to communicate with the Ekahau RTLS engine. The port range must be
between 1000 and 9000.
7. Click the Apply button to save the Multicast MAC Address, IP Address and Port information
8. Click the Revert button to cancel any changes made within Multicast MAC Address, IP Address and
Port settings and revert back to the last saved configuration.
9. If the Multicast MAC Address, IP Address and Port values are configured and Ekahau RTLS support
is enabled the following information will be displayed:
10.To use the onboard SOLE engine to locate Ekahau tags check the Enable checkbox. This is enabled
immediately after checking the box.
11.If the onboard SOLE engine is enabled to locate Ekahau tags, enter a Locate Interval in seconds to
specify how often the known tags are located by the SOLE engine.
12.Click the Apply button to save the Locate Interval value.
13.Click the Revert button to cancel any changes made within Locate Interval value and revert back to
the last saved configuration.
If the onboard SOLE engine is enabled to locate Ekahau tags the following information will be displayed for
each located MU:
NOTE: To use the onboard SOLE engine to locate Ekahau tags, site parameters, AP
location (Command Line Interface only) and Zone configuration (optional, Command Line
Interface only) must be configured.
IP Address Displays the IP address of the external Ekahau RTLS engine.
Port Displays the port number which the switch uses to connect to the external Ekahau
RTLS engine.
MAC Lists the MAC Addresses of all MUs which have been located by the switch.
Location:
X Coordinate
Displays the value of the X Coordinate for each located MU. The X coordinate is
relative to the origin point of 0,0 in the upper left corner of the site map.
Location:
Y Coordinate
Displays the value of the Y Coordinate for each located MU. The X coordinate is
relative to the origin point of 0,0 in the upper left corner of the site map.
Timestamp Displays the last time for each MU that its location was computed by the switch.
Zone Lists the last known zone for each located MU. Zone configuration can be defined
using the CLI interface only. When no zones are configured, the switch defaults
the entire site to Zone 0.
NOTE: Zone configuration can be defined using the CLI interface only. For information on Zone
Configuration please see the Motorola RF Switch CLI Reference.