Installation guide

5-68 Motorola RF Switch System Reference
2. Select the Aeroscout tab.
3. Check the Enable checkbox to globally enable Aeroscout RTLS support on the switch.
This takes effect immediately when the box is checked.
4. Enter the Multicast MAC Address used for all Aeroscout tags to send updates via multicast to the
MAC address specified. Typically the MAC address will start with 01-0C-CC-XX-XX-XX.
5. Click the Apply button to save the Multicast MAC Address value.
6. Click the Revert button to cancel any changes made within Multicast MAC Address value and revert
back to the last saved configuration.
7. If the Multicast MAC Address is configured and Aeroscout support is enabled the following
information will be displayed:
8. To use the onboard SOLE engine to locate Aeroscout tags check the Enable checkbox. This is enabled
immediately after checking the box.
9. If the onboard SOLE engine is enabled to locate Aeroscout tags, enter a Locate Interval in seconds to
specify how often the known tags are located by the SOLE engine.
10.Click the Apply button to save the Locate Interval value.
11.Click the Revert button to cancel any changes made within Locate Interval value and revert back to
the last saved configuration.
NOTE: To use the onboard SOLE engine to locate Aeroscout tags, site parameters, AP
location (Command Line Interface only) and Zone configuration (optional, Command Line
Interface only) must be configured.
IP Address Displays the IP address of the external Aeroscout RTLS engine.
Port Displays the port number which the switch uses to connect to the external
Aeroscout RTLS engine.