Installation guide

Switch Services 5-47
2. Configure redundancy settings using the Command Line Interface or the using the Web UI as described
in Configuring Redundancy Settings on page 5-36.
3. Add any redundancy group members using the Command Line Interface or using the Web UI as described
in Configuring Redundancy Group Membership on page 5-42.
4. On the Configuration tab, check the Enable Redundancy checkbox and then check the Enable Cluster
GUI box.
5. Click the Apply button to enable the Cluster GUI feature.
6. Once Cluster GUI is enabled a Switch field will be available in many of the Access Port and mobile unit
related screens. The Switch field is displays which cluster members the APs and MUs are associated
with identified by their IP address.
NOTE: When accessing the switch Web UI through a NATed interface the Cluster GUI
features will only be accessible if TCP ports 80 and 161 are opened on the router or
gateway.