Installation guide

Switch Services 5-23
4. Use the Pool Name field to define a new pool name. Enter the pool name created using Adding a New
DHCP Pool on page 5-6.
5. Use the Class Name field to associate an existing class, created using Adding a New DHCP User Class
on page 5-19.
6. The Pool Class Address Range field is used to assign address range to the class inside the pool. A
maximum of 4 address ranges can be assigned to a class.
a. Use the Insert button to enter the Start IP and End IP address range for a class.
b. Select a address range and click Remove to delete that particular address range.
7. Refer to the Status field. It displays the current state of the requests made from the applet. Requests are
any “SET/GET” operation from the applet. The Status field displays error messages if something goes
wrong in the transaction between the applet and the switch.
8. Click OK to save the new configuration and close the dialog window.
9. Click Cancel to close the dialog without committing updates to the running configuration.