Installation guide

Network Setup 4-131
The Properties field displays the Model family for the selected Access Port. The Model is read only
and cannot be modified. The Radio Type displays the radio type (802.11a or 802.11bg). This value is read
only and cannot be modified
5. To use this radio as a detector to identify rogue APs on your network, check the box titled Dedicate this
AP as Detector AP. Setting this radio as a detector will dedicate this radio to detecting rogue APs on
the network. Dedicated detectors do not connect to by clients.
6. Select the Single-channel scan for Unapproved APs checkbox to enable the switch to detect rogue
devices using its only its current channel of operation.
7. Select the Enable Enhanced Beacon Table checkbox to allow the AP to receive beacons and
association information.
8. Select the Enable Enhanced Probe Table checkbox to allow an AP to forward MU probe requests to
the switch.
9. Within the Radio Settings field, configure the Placement of the radio as either Indoors or Outdoors.
The setting will affect the selection channel and power levels. Default is Indoor.
10.Select a channel for communications between the Access Port and MUs in the Desired Channel field.
The selection of a channel determines the available power levels. The range of legally approved
communication channels varies depending on the installation location and country. The selected channel