Installation guide

4-114 Motorola RF Switch System Reference Guide
4.7.6 Configuring Radio Groups for MU Load Balancing
In order to do MU load balancing, radios must be grouped. Usually, two radios with similar characteristics
and geographically close to each other can be grouped together.
By default, a radio is not in any group and the load balancing algorithm would not apply to it.
To configure a group of radios together:
1. Select Network > Access Port Radios from the main menu tree.
2. Go to the Configuration tab.
3. Select a radio you wish to add to a group and click the Edit button.
4. Enter the Group ID for the group you wish to add the selected radio to.
5. Click OK to save the changes.
6. Repeat steps 3 through 5 for each radio you wish to add to groups.
7. When you have finished adding radios to groups, click the Apply button on the Configuration tab to
save your changes.
8. To verify the radio groups click on the Groups tab to view configured radio groups. For more information
on viewing radio groups refer to Viewing Access Point Radio Groups on page 4-115.
Description The displayed name is the name used with the device radio. Use this name (along
with the radio index) to differentiate the radio from other device radios.
QoS Weight Displays the Quality of Service weight for the AP. The default value for the weight
is 1. AP QoS will be applied based on the QoS weight value with the higher values
given priority.