Installation guide

4-92 Motorola RF Switch System Reference Guide
4. Refer to the Properties field for the following
5. Click the Edit button to launch a screen used to configure radio specific parameters. For more
information, see Editing AP Settings on page 4-95.
Adopted Displays the radio’s adoption status. If the radio is adopted, a green check
displays. If the radio is not adopted, a red X displays.
Parent AP MAC
Address
Displays the Access Port's Ethernet MAC (the device MAC address that is printed
on the casing of the unit). Please do not confuse this BSSID MAC with the Access
Port's Ethernet MAC address.
MAC Address The Base Radio MAC is the radio's first MAC address when it is adopted by the
Switch.
State Display the radio’s current operational mode. If the radio is set as a Detector AP,
the state is "Detector", otherwise the state is "Normal".
VLAN Displays the name of the VLAN currently used with each Access Port radio.
Desired Channel When the radio’s channel is configured statically, the Actual Channel and Desired
Channel are the same. If using ACS (Automatic Channel Selection), the switch
selects a channel for the radio. The Desired Channel displays “ACS” and the
Actual channel displays the channel selected for the radio. When set to Random,
the applet determines the channel’s designation.
AP Manufacturer Displays the kind of AP listed by each index.
Actual Channel When the radio’s channel is configured statically, the Actual Channel and Desired
Channel are the same. If using ACS (Automatic Channel Selection), the switch
selects a channel for the radio. The Desired channel displays “ACS” and the
Actual Channel displays the channel selected for the radio.
Desired Power (dBm) Displays the configured power setting in dBm for the selected radio. In most
cases, the Desired Power and Actual Power are the same unless the desired
power level would put the radio's output power outside the accepted regulatory
compliance range.
BSSIDs Displays the BSSIDs used by the displayed radio index.
Actual Power Displays the current power level in dBm for the selected radio. In most cases, the
Desired Power and Actual Power are the same unless the desired power level
would put the radio's output power outside the accepted regulatory compliance
range.
Placement When the radio is adopted using the default configuration, the power for the radio
can be defined as “Indoor” or “Outdoor.” However, some countries have
restrictions for the use of outdoor radios. If using a value of “Outdoor” verify it is
in compliance with the country of operation’s regulatory restrictions.
AP IP Address Displays the AP’s IP address.
Last Adopted Displays the time this radio was last adopted by the switch.
AP IP Address Mask Displays the net mask address associated with the selected Access Port IP
Address.
Voice Calls Displays the current number of active voice calls for the selected radio.