Installation guide

4-30 Motorola RF Switch System Reference Guide
8. Refer to the Advanced field for the following information:
Accounting Mode
If using a Syslog server to conduct accounting for the switch, select the Syslog
option from the Accounting Mode drop-down menu. Once selected, a Syslog
Config button is enabled on the bottom of the Network > Wireless LANs > Edit
screen. Use this sub screen to provide the Syslog Server IP address and port for the
Syslog Server performing the accounting function.
If either Hotspot, MAC Authentication or 802.1x EAP have been selected from
within the Authentication field, a Radius Config button is enabled (on the bottom
of the screen) allowing the user to define a Primary and Secondary Radius
Accounting Server IP address, port, shared secret password and timeout and retry.
Define these accounting settings as required for the switch.
The default Accounting Mode setting is Off.
Answer Broadcast
ESS
Select this checkbox to allow the WLAN to respond to probes for broadcast ESS.
Use Voice
Prioritization
Select the Use Voice Prioritization option if Voice is used on the WLAN. This gives
priority to voice packets and voice management packets and is supported only on
certain legacy Motorola VOIP phones.
Enable SVP Enabling SVP (Spectralink Voice Prioritization) allows the switch to identify and
prioritize traffic from Spectralink/Polycomm phones.
Secure Beacon Closed system is the secure beacon feature for not answering broadcast SSID.
This option still allows MU to MU communication within the WLAN.
QoS Weight Sets the Quality of Service weight for the WLAN. WLAN QoS will be applied
based on the QoS weight value with the higher values given priority.The default
value for the weight is 1.
MU to MU Traffic Allows frames from one MU (where the destination MAC is of another MU) are
switched to a second MU. Use the drop-down menu to select one of the following
options:
• Drop Packets – This restricts MU to MU communication based on the WLAN’s
configuration
• Allow Packets – This allows MU to MU communication based on the WLAN’s
configuration
MU Idle Time Set the MUs idle time limit in seconds. The default value is 1800 seconds.
Access Category Displays the Access Category for the intended traffic. The Access Categories are
the different WLAN-WMM options available to the radio.
The Access Category types are:
• Automatic/WMM – Optimized for WMM
• Voice – Optimized for voice traffic. Voice packets receive priority.
• Video – Optimized for video traffic. Video packets receive priority.
• Normal – Optimized for normal traffic
• Low – Optimized for background traffic
MCast Addr 1 The address provided takes packets (where the first 4 bytes match the first 4 bytes
of the mask) and sends them immediately over the air instead of waiting for the
DTIM period. Any multicast/broadcast that does not match this mask will go out
only on DTIM Intervals.