Installation guide

Network Setup 4-17
9. Refer to the Status field for the current state of the requests made from applet. This field displays error
messages if something goes wrong in the transaction between the applet and the switch.
10.Click OK to use the changes to the running configuration and close the dialog.
11.Click Cancel to close the dialog without committing updates to the running configuration.
4.4.1.2 Modifying a Virtual Interface
To modify an existing virtual interface.
1. Select Network > Switch Virtual Interface from the main tree menu.
2. Select the Configuration tab and click the Edit button.
The screen displays with the name of the VLAN in the upper left-hand side. The VLAN ID cannot be
modified and should be used to associate the VLAN ID with the description and IP address assignments
defined.
3. If necessary, modify the Description of the VLAN, to make it representative of the VLAN’s intended
operation within the switch managed network.
4. Unselect the Use DHCP to obtain IP Address automatically checkbox to assign IP addresses
manually and you do not want DHCP to provide them.
5. Use the Primary IP Address field to manually enter the IP address for the virtual interface.
6. Enter the Subnet Mask for the IP address.
7. Select the Set as Management Interface checkbox to convert the selected VLAN ID to a management
interface.
CAUTION: When changing from a default DHCP address to a fixed IP address, set a static
route first. This is critical when the switch is being accessed from a subnet not directly
connected to the switch and the default route was set from DHCP.
!