Installation guide

4-16 Motorola RF Switch System Reference Guide
5. Click the Add button to add a new configuration to the switch virtual interface. For more information, see
Adding a Virtual Interface on page 4-16.
6. Select an interface as click the Startup button to invoke the selected interface the next time the switch
is booted.
7. Select an interface as click the Shutdown button to disable the selected interface.
4.4.1.1 Adding a Virtual Interface
To add a new switch virtual interface:
1. Select Network > Switch Virtual Interface from the main tree menu.
2. Select the Configuration tab.
3. Click on the Add button.
4. Enter the VLAN ID for the switch virtual interface.
5. Provide a Description for the VLAN, representative of the VLAN’s intended operation within the switch
managed network.
6. The Primary IP Settings field consists of the following:
a. Select Use DHCP to obtain IP Address automatically to allow DHCP to provide the IP address
for the virtual interface. Selecting this option disables the IP address field.
b. Enter the IP Address for the VLAN associated virtual interface.
c. Enter the Subnet Mask for the IP address.
7. Select the Set as Management Interface checkbox to enable any host displayed in this VLAN to
configure the switch.
8. Use the Secondary IP Addresses field to define additional IP addresses to associate with VLAN IDs.
The address provided in this field is used if the primary IP address is unreachable.
Select the Add button (within the Secondary IP Addresses field) to define additional addresses from a
sub screen. Choose an existing secondary address and select Edit or Delete to revise or remove a
secondary address.