Installation guide

RFS4010 RF Switch: Installation Guide
18
2. On the configuration computer, configure a terminal emulation application
(such as HyperTerminal) as follows:
4.6 Supplying Power to the RFS4010 RF Switch
1. Plug the power supply (Motorola Part Number: 50-14000-244R) into the power inlet at the back
of the RFS4010 RF Switch.
2. Plug the cord into a standard AC outlet with a voltage range of 100 to 240 VAC.
Terminal Type VT-100
Port COM port
Terminal Settings
19200bps transfer rate
8 data bits
no parity
1 stop bit
no flow control
no hardware compression
Power Inlet