Installation manual
Diagnostics
B
QIP7000 (P2) Series Hybrid QAM/IP HD Set-top Terminal • Installation Manual 41
574702-001 a This document is uncontrolled pending incorporation in a Motorola CMS
The Out-Of-Band Status fields are:
Field Description
OOB Frequency Indicates the OOB tuner center frequency, from 70 to 130 MHz.
Carrier Lock Indicates whether the OOB receiver is locked to the carrier:
OSD Front Panel Description
YES L Carrier locked
NO U Carrier unlocked
Data Indicates whether data is being carried by the OOB and EMM traffic, which is
tracked separately:
OSD Front Panel Description
YES On OOB data detected within last 5 seconds
NO Off OOB data not detected within last 5 seconds
EMM Data Indicates whether EMM data is being carried on the OOB stream:
OSD Front Panel Description
YES On EMM data detected within last 5 seconds
NO Off EMM data not detected within last 5 seconds
SNR When carrier lock has been established, displays an estimate of the carrier
signal-to-noise ratio in dB, with an explanation:
• GOOD — Good value
• FAIR — Marginal signal level, check the signal
• POOR — Unusable signal
• INVALID — Invalid SNR value
AGC When carrier lock has been established, displays an estimate of the AGC as a
percentage, with an explanation:
• GOOD — Good value
• FAIR — Marginal signal level, check the signal
• POOR — Unusable signal
• INVALID — Invalid AGC value
EMM Provider ID Displays the conditional access stream for the QIP7000 series, in hexadecimal.
EMM PID Displays the packet identifier (PID) stream the QIP7000 series tunes to for EMM
data, in hexadecimal.
Network PID Displays the network PID to which the QIP7000 series is tuned to receive
network messages, in hexadecimal.
Hunt Mode The hunt mode includes Hunted, None, Round Robin (RR), Search (SRCH), Fixed
Frequency (FIX), or EMM Provider ID (EMM).
LKC The last known carrier is the last valid OOB frequency displayed in MHz and
ranges from 70 to 130 MHz, with the specific values of: 75.25, 104.20, 72.75,
92.25, 98.25, 107.25, 107.40, 110.25, 116.25, and 103.75.
LKC will remain blank during hunting if a valid carrier has not been found, and will
be populated once a valid OOB is found.
Man Pag Only displayed when QIP7000 series is not hunting and the operator presses
“menu” button. The operator can then scroll up or down to one of the specific
OOB frequencies.