Installation manual

Overview
B
QIP7000 (P2) Series Hybrid QAM/IP HD Set-top Terminal • Installation Manual 7
574702-001 a This document is uncontrolled pending incorporation in a Motorola CMS
Figure 4 – Rear panel
Table 3 – Rear panel connections
Lable Description
1 FiOS TV In — Connects to FiOS signal from your service provider
2 RF Out — Ch 3/4 modulated audio/video (SDTV) to TV or VCR
3 IEEE-1394 — Audio and video device connection
4 YPbPr — Component video output (HDTV)
5 Audio — Composite Audio L/R outputs
6 Video — Composite Video (SDTV) output
7 Digital Audio (RCA)* — Provides Dolby
®
Digital 5.1 audio or PCM output
8 Optical Audio (S/PDIF)* — Provides Dolby
®
Digital 5.1 audio or PCM output
9 S-Video — Connects to S-Video (SDTV) input of TV or VCR
10 IR Remote Input — Connects to a remote control set-top accessory cable
11 HDMI — High-Definition TV (HDTV) connector
12 eSATA* — External Serial ATA disk interface (QIP7200 Only)
13 Ethernet* — Network connection
14 USB* 2.0 — High-Speed peripheral device connection
15 Reserved – Service only
16 Power cord connector — switched accessory 2 prong AC outlet
*Feature is dependent upon application setting and availability in content
M-Card™
The M-Card is required to view television programs, previously recorded programs on
the DVR, or interactive on-demand programs. The M-Card should not be removed.