Computer Hardware User Manual

PrPMC800/800ET Processor PMC Module Installation and Use (PrPMC800A/IH5)
Index
71
parameter (Primary SCSI Bus Negotiations) 51
parameter (Primary SCSI Data Bus Width) 51
parameter (ROM Boot Enable) 53
parameter (SCSI bus reset on debugger startup) 51
parameter (Secondary SCSI identifier) 51
P
parity on debug serial port 11
PCI interface 24
PCI interrupt signals 25
physical dimensions, PrPMC board 57
pin assignments
configuration header 5
debug header (J1) 35
Ethernet adapter connector (J3) 35
Harrier power-up configuration header 37
PMC connector P11 29
PMC connector P12 31
PMC connector P13 32
PMC connector P14 33
PMC connectors 29
PMC connectors 24
, 29
power requirements 23
powering up the PrPMC 9
PPC7-Bug> 40
, 46
PPC7-Diag> 40
, 46
PPCBug
basics 39
command syntax 42
commands 42
debugger firmware 49
functionality 40
memory requirements 40
prompt 40
pre-install checklist 3
PRESENT# signal 25
Primary SCSI Bus Negotiations parameter 51
Primary SCSI Data Bus Width parameter 51
prompts, debugger 40
, 46
PrPMC
description 1
firmware 2
flash memory 19
general description 14
Harrier ASIC 16
MONARCH# signal 25
on-board SROM 20
PCI interrupt signals 25
PMC connectors 29
PRESENT# signal 25
voltage requirements 23
PrPMC board
configuration 4
initialization 9
installation 7
LEDs 10
status indicators 10
R
related documentation 65
related specifications 67
reset logic 23
reset signal 25
reset sources 23
RESET# signal 26
RESETOUT_L signal 25
restart mode 47
RF emissions 58
ROM Boot Enable parameter 53
ROM First Access Length parameter 55
ROMboot enable 55
ROMboot Enable parameter 53
, 55
ROMFAL 55
ROMNAL (ROM Next Access Length) parameter 55
routing of interrupts 22
RS-232 port 11
S
SCSI bus 51
SCSI reset on debugger startup 51
SD command 46
Secondary SCSI identifier 51
serial debug port 22
serial port configuration 11
Set Environment to Bug/Operating System (ENV)
command 50
shielded cables (see also cables) 58
signals
ABORT# and RESET# 26
EREADY 26
IDSELB, REQB#, GNTB# 25
INTA#-INTD# 25
M66EN 25
PRESENT# 25
slave/target, PrPMC role 2
slot requirements 2
SPD (Serial Presence Detect) data
where stored 20
specifications 57
, 59
SROM on the PrPMC 20
start-up procedures 3
status indicators, location of 10
status LEDs 26
stop bits per character, debug serial port 11
system enclosure requirements 2
T
temperature measurement 60, 62, 63
temperatures, component 59
testing the hardware 46
thermal performance 59
timers on Harrier ASIC 21
troubleshooting the PrPMC 46
U
unpacking the hardware 4