Computer Hardware User Manual

PrPMC800/800ET Processor PMC Module Installation and Use (PrPMC800A/IH5)
Index
70
Primary SCSI Data Bus Width 51
ROM Boot Enable 53
SCSI Bus Reset on Debugger Startup 51
Secondary SCSI identifier 51
environmental parameters 49
environmental specifications 58
EREADY signal 26
ESD precautions 7
Ethernet
adapter (J3) connector pinouts 35
channel 21
controller 21
port adapter cable 11
power-up configuration information 21
Ethernet, connections 1
evaluating thermal performance xviii
, 59
F
FAIL LED 26
features
hardware 13
Harrier ASIC 16
firmware on PrPMC 2
firmware, PPCBug 39
initialization 41
flash memory on PrPMC 19
G
general description, PrPMC 14
generation of interrupts 22
H
half-word, definition of xix
hardware
configuration 4
diagnostics 46
features 13
initialization 41
Harrier ASIC
arbitration 19
Control and Status register 21
functionality on PrPMC board 16
power-up configuration 17
power-up configuration header 5
, 26
power-up configuration header pinouts 37
HE (Help) command 46
header
debug 26
Harrier power-up configuration 26
heatsink, machining 63
Help (HE) command 46
host board interface 1
host/master function
role of PrPMC 2
host/slave function
carrier board requirements 2
I
IDSELB, REQB#, GNTB# signals, use of 25
initialization process
as performed by firmware 41
on PrPMC 9
installing the PrPMC board 8
INTA#-INTD# signals 25
interrupts 22
L
L2 Cache Parity Enable parameter 55
LED/serial startup diagnostic codes 55
LEDs 10
LEDs, status 26
little-endian byte ordering xx
location of jumper headers, connectors, components 4
lowercase characters, commands and 47
M
M66EN signal 25
manufacturers’ documents 66
mechanical characteristics 57
memory
flash 19
SDRAM 20
memory maps 27
memory requirements, PPCBug 40
memory size 54
memory size enable parameter 54
Miscellaneous Control and Status register 21
modes, master and slave 1
monarch and non-monarch modes 1
monarch operations with carrier board 2
MONARCH# signal 25
monarch, designation as host/master 2
Motorola documents 65
MPU initialization 41
N
NETboot Enable parameter 53
network auto boot controller parameter 53
network auto boot enable parameter 53
NIOT debugger command, use of 54
non-monarch, designation as slave/target 2
Non-Volatile RAM (NVRAM) 49
, 50
NVRAM Bootlist parameter 51
O
onboard SDRAM 20
operating parameters 49
operating temperatures, maximum 59
operation
parameter (Auto Boot Abort Delay) 53
parameter (Auto Boot Controller) 52
parameter (Auto Boot Default String) 53
parameter (Auto Boot Device) 52
parameter (Auto Boot Partition Number) 52
parameter (L2 Cache Parity Enable) 55
parameter (Memory Size) 54
parameter (Network Auto Boot Controller) 53
parameter (NVRAM Bootlist) 51