Computer Hardware User Manual

PrPMC800/800ET Processor PMC Module Installation and Use (PrPMC800A/IH5)
6 Modifying the Environment
56
imposed by storing the ENV parameters in flash, the Serial Startup
codes are disabled for PrPMC800/800ET. The codes are enabled by an
ENV parameter:
Serial Startup Code Master Enable [Y/N]=N?
A line feed can be inserted after each code is displayed to prevent it from being
overwritten by the next code. This is also enabled by an ENV parameter:
Serial Startup Code LF Enable [Y/N]=N?
The list of LED/serial codes is included in the section on MPU, Hardware, and
Firmware Initialization in Chapter 1 of the PPCBug Firmware Package User’s
Manual.