Computer Hardware User Manual

1 Preparation and Installation
PrPMC800/800ET Processor PMC Module Installation and Use (PrPMC800A/IH5)
3
Overview of Start-Up Procedures
The following table lists the things you need to do before you can use this board and tells where
to find the information you need to perform each step. Be sure to read this entire chapter,
including all Cautions and Warnings, before you begin.
Table 1-3. Start-Up Overview
What you need to do ... Refer to ... On page
...
Unpack the hardware. Unpacking the PrPMC800/800ET
Hardware
4
Make any settings or
adjustments on the
PrPMC800/800ET module.
Preparing the PrPMC800/800ET Hardware 4
PrPMC800/800ET Configuration
Considerations
4
Prepare any other optional
devices or equipment you will
be using.
For more information on optional devices
and equipment, refer to the documentation
provided with that equipment.
Install the PrPMC800/800ET on
the baseboard.
Installation of a PrPMC800/800ET on a
VME or CompactPCI board
7
Connect any other optional
devices or equipment you will
be using.
Connector Pin Assignments 29
For more information on optional devices
and equipment, refer to the documentation
provided with that equipment.
Power up the system. Status Indicators 10
You may also wish to obtain the PPCBug
Diagnostics Manual, listed in Appendix C,
Related Documentation.
65
Examine the environmental
parameters and make any
changes needed.
ENV - Set Environment 50
You may also wish to obtain the PPCBug
Firmware Package User’s Manual, listed in
Appendix C, Related Documentation.
65
Program the PrPMC800/800ET
module and PMCs as needed
for your applications.
Preparing the PrPMC800/800ET Hardware 4
You may also wish to obtain the
PrPMC800/800ET Processor PMC Module
Programmer’s Reference Guide, listed in
Appendix C, Related Documentation.
65