User's Guide
Table Of Contents
- 1. Safety Instructions
- 2. Getting Started
- 2.1 Baby Unit Power Supply
- 2.2 Parent Unit Battery Installation
- 2.3 Parent Unit Power Supply
- 3. Using the Baby Monitor
- 3.1 Setting Up
- 3.2 Power On or Off the Baby Unit
- 3.3 Power On or Off the Parent Unit
- 3.4 Night Vision Mode
- 3.5 Turn off Parent Unit LCD Screen
- 4. Parent Unit Menu Options
- 4.1 Adjust Speaker Volume
- 4.2 LCD Brightness
- 4.3 Set Alarm Time on the Parent Unit
- 4.3.1 Set lullaby
- 4.4 Monitor the Temperature
- 4.4.1 Temperature Format
- 4.4.2 Temperature Range
- 4.4.3 Temperature Alert
- 4.5 Remove a Baby Unit from the Parent Unit
- 4.6 Set Screen Off time for the Parent Unit
- 4.7 Zoom, Pan or Tilt
- 4.8 Pair and Replace a Baby Unit
- 4.9 Multi-Camera Use
- 5. Disposal of the Device (environment)
- 6. Cleaning
- 7. Troubleshooting
- 8. General Information
10 Getting Started
2. Getting Started
2.1
Connecting the Power Supply for the Baby Unit
1. Plug the DC plug of the power adapter into the power socket on the rear of
the baby (camera) unit and plug the other end of the AC adapter into the
wall socket.
2.
The baby unit turns on and the power indicator lights up in blue.
WARNING
Strangulation Hazard. Children have STRANGLED in cords. Keep this cord out
of the reach of children (more than 1 meter or 3 feet away). Do not remove the
tags from the AC Adapters. Only use the AC Adapters provided.
2.
2 Connecting the power supply of the Parent Unit
A rechargeable battery is already pre-installed inside the parent unit. When
fully charged, you can move the parent unit without losing the link and picture
from the baby (camera) unit. When charging the battery for the first time,
charge for at least 16 hours continuously.
1. Plug the DC plug of the power adapter into the power socket on the side
of the parent unit and plug the other end of the AC adapter into the wall
socket.
Press and hold