user manual

1-6 Computer Group Literature Center Web Site
Hardware Preparation and Installation
1
MVME2603/2604 Base Board Preparation
Figure 1-2 on page 1-9 illustrates the placement of the switches, jumper
headers, connectors, and LED indicators on the MVME2603/2604.
Manually configurable items on the base board include:
❏ Cache mode control (J3)
❏ Flash bank selection (J10)
❏ Serial Port 4 receive clock configuration (J16)
❏ Serial Port 4 transmit clock configuration (J17)
❏ Serial Port 4 transmit clock receiver buffer control (J20)
❏ Serial Port 3 transmit clock configuration (J18)
❏ System controller selection (J22)
In conjunction with the serial port settings on the base board, serial ports
on the associated MVME712M or MVME761 transition module are also
manually configurable. For a discussion of the configurable items on the
transition module, refer to MVME712M Transition Module Preparation
on page 1-14, MVME761 Transition Module Preparation on page 1-25, or
to the respective user’s manuals for the transition modules (listed in
Appendix D, Related Documentation) as necessary.
The MVME2603/2604 is factory tested and shipped with the
configurations described in the following sections. The
MVME2603/2604’s required and factory-installed debug monitor,
PPCBug, operates with those factory settings.