user manual

1-4 Computer Group Literature Center Web Site
Hardware Preparation and Installation
1
Install the transition module in the
chassis.
MVME712M Transition Module Installation on page
1-44 or MVME761 Transition Module Installation on
page 1-48
Connect a console terminal. System Considerations on page 1-50, MVME2603/2604
VME module
Connect any other equipment you
will be using.
Chapter 4, Connector Pin Assignments
For more information on optional devices and
equipment, refer to the documentation provided with the
equipment.
Power up the system. Applying Power on page 2-1
Appendix C, Troubleshooting CPU Boards: Solving
Startup Problems
Note that the debugger initializes
the MVME2603/ 2604.
Using the Debugger on page 5-3
You may also wish to obtain the PPCBug Firmware
Package User’s Manual, listed in Appendix D, Related
Documentation.
Initialize the system clock. Using the Debugger on page 5-3, Debugger Commands,
the SET command
Examine and/or change
environmental parameters.
Chapter 6, CNFG and ENV Commands
Program the board as needed for
your applications.
MVME2600 Series Single Board Computer
Programmer’s Reference Guide, listed in Appendix D,
Related Documentation.
Table 1-1. Startup Overview (Continued)
What you need to do... Refer to...